The ARX MaxiDrive Line Driver and Distribution Amplifier provides Six High Current Line outputs from Six inputs. Each Output can be linked to the preceding one to provide any configuration required. For example: 6 In, 6 Out, 2 x sets of 1 In, 3 Out, 1 In, 6 Out or similar can be set up simply by pressing the Link switches to link a channel to its predecessor. The MaxiDrive's intuitive layout and clear, uncluttered labelling enables a quick and easy solution to the increasing demands of today’s standards of audio production. Probably the single biggest improvement you can make to a Line Array system? With the advent and widespread use of large self powered line array loudspeaker systems, the change in system signal drive requirements has been missed by many Signal Processor / DSP Processor Designers and Manufacturers. The product design engineers at ARX realise that the real work doesn't end at the male XLRs on the rear of the system processor. However, it seems manufacturers have given little consideration to what follows on in the signal chain, nor the demands multiple loudspeaker input impedance loads place on processor output stages. The perceived grittiness and lack of clarity at high operating levels sometimes attributed to the Loudspeaker system's performance can be more probably attributed to the inability of the preceding signal processors in the audio chain to drive low impedance loads at high voltage levels over long reactive cables, which present both a capacitive and inductive load to the output drive stage. In short, you need a line driver that can comfortably drive multiple inputs per channel with the headroom required fo