Audio Production Equipment : Amplifiers (Audio) : Biamp - Vocia VA-2060e

Vocia® Amplifier (VA-2060e)

Series: Vocia®

Model: Vocia VA-2060e

Part #: 0321.900

Tw-channels of 60W RMS per channel
Transformer coupled outputs, low impedance (4 or 8 ohms) or 25V, 70V or 100V (hardware selectable)
Comprehensive failover
-Device-to-device
-All-to-1 channel

More Product Information Below

Compare

Project List

Product Info

Tech Specs

Documents

The VA-2060e is a digital networked, two-channel amplifier for use in Vocia® systems. It is capable of delivering continuous power at 60 Watts RMS per channel. The VA-2060e is CobraNet® enabled for audio and control with dynamic use of bundles. It has local analog inputs and dual power supply. Two RJ45 connectors on the rear panel provide redundant CobraNet connectivity to the Vocia network. The on-board DSP provides comprehensive fixed-chain, digital signal processing within the device. In addition, emergency messages can be stored in local non-volatile memory. Page active relay outputs provide a contact closure per channel when paging is active on the channel. The amplifier offers low impedance and constant voltage outputs. The VA-2060e also has comprehensive failover capability with device-to-device and channel-to-channel failover. EN 54-16 certification pending.

Tw-channels of 60W RMS per channel
Transformer coupled outputs, low impedance (4 or 8 ohms) or 25V, 70V or 100V (hardware selectable)
Comprehensive failover
-Device-to-device
-All-to-1 channel
-1:1 channel
Supports Page Active Relay (PAR), ELD-1 and ANC-1
Local non-volatile storage of emergency messages
LED status and signal indication
Software-configurable signal processing including volume control, filters, compressor/limiting, delay, speaker equalization and output sensitivity
CobraNet audio/control with dynamic use of available bundles
Local background source support with single mic/line analog audi-input for each channel (gain-adjustable, switchable phantom power)
Dual power supply
-AC Mains
-Single or Dual 24V DC inputs
Dual Ethernet ports for redundancy
Rotary switches for device identification
Rack mountable (2RU)
EN 54-16 certified, CE marked, UL listed and RoHS compliant
Covered by Biamp Systems’ warranty

Amplifier Signal Type - Audio
Amplifier Type - Power Amplifier
Spec Sheet available - Yes

Depth: 361 mm
Height: 82.50 mm
Width: 483 mm
Product Weight: 11.30 kg
Operating Temperature (Maximum): 41.67 C
Operating Temperature (Minimum): -3.33 C
Maximum Frequency Response (Bandwidth): 20 kHz
Maximum Frequency Response (Bandwidth): 20000 Hz
Minimum Frequency Response (Bandwidth): 40 Hz
Minimum Frequency Response (Bandwidth): 0.04 kHz
Memory: 5.625 MB
Inputs: 20 bits, 48 kHz, 5-1/3 ms (fixed)
Frequency Response: 40Hz-20kHz +/- 2dB
Signal to noise ratio: >88dB, unweighted
THD + Noise:
<0.5% 50Hz-100Hz
<0.3% 100Hz-10kHz
Connections:
Network: RJ45 with shielded Ethernet (Cat5, Cat5e, Cat6 or Cat7)
Terminal block connectors (analog inputs)
Total Output Power: 2 x 60W RMS, 120W maximum
Environment:
Ambient intake humidity: 0-100% (non-condensing)
Altitude: 0-10,000 Feet MSL (0-3,000m)
Power:
100-240VAC; 50/60Hz
Single or Dual 24V DC source (not supplied)
Compliance:
EN 54-16 certified
FCC Part 15B
CE marked
UL 60065 and C-UL listed
CCC pending
C-Tick
RoHS Directive
EN 60849, AS 60849 verified

Vocia_VA-2060e_Data_Sheet_(Jun11).pdf 525 kb - Data Sheet

Project List

Vocia Product Catalog 9064 kb - Brochure

Project List

Find a Dealer

Find a Distributor

Included in Case Studies

Biamp Systems - St. Vincent Medical Center

in Portland, OR, USA

by Biamp

Suggested Products

DM NAX 4+1 Zone Streaming Amplifier

by Crestron Electronics, Inc.

8-Channel Power Amplifier, 75W/Ch., 4/8 Ohm or 70V, North America and Japan, 100-120V

by Crestron Electronics, Inc.

8-Channel Power Amplifier, 150W/Ch., 4/8 Ohm or 70V, North America and Japan, 100-120V

by Crestron Electronics, Inc.